Netgear Router Not Working After Reset? Let’s Fix It!
Did you just reset your Netgear WiFi router? Has it stopped working after the reset process? Fret not! We are here to assist you. There are many situations that may put you in a situation to reset your router to the factory settings. Routerlogin.net not working, corrupted firmware, forgotten login password and very poor WiFi signals are some possible situations. However, it is recommended to use the reset process only when you have tried all other possible remedies to the problem that you are facing. We hope your situation was similar to one of those mentioned here.
So, your router is not working right after the reset process. We hope you are aware of the fact that you are supposed to set up the router from scratch after you have restored the factory settings on your router. Thus, if you haven’t done that yet, then do it immediately. However, if the router is not working even after setting it up again then let us help you fix that. Let’s get started!
Netgear Router Stopped Working After Reset [Fixed]
Fix 1: Verify the Process
Have you followed the correct procedure to reset your Netgear router? There are two ways using which you can reset the router. One is the hard reset method which involves pressing a button. The other way to reset the router is the soft reset method which involves logging in to the Netgear admin login page using a web browser.
Make sure that you have followed the correct method to reset your device whatever method you chose.
Fix 2: Reboot the Router
Technical glitches are one of the most common reasons why technical devices get stuck. Power outages are mostly the culprit behind these technical glitches. So, get your Netgear router rid of them by performing a simple reboot process. Reboot or restart or power cycle is nothing but a simple process that will help you get rid of temporary technical issues with the device. This will also give some rest to it. You can reboot your router by turning it off and disconnecting it from the power outlet. Also, disconnect every other cable that is connected to it. After about a minute, connect the cables back in the same way as earlier. Plug the router back into the power socket and turn on its power button.
Has the issue got fixed now? We hope that your Netgear router is up and working now after rebooting the router.
Fix 3: Check the Connections
If the issue still exists after rebooting also, then check the power supply to the router once. Maybe the power socket is broken or the power adapter is not plugged in properly. Ensure a non-fluctuating power supply to the router.
After checking the power supply, take a look at the way the router is connected to the modem. Maybe while you were setting up the router after resetting it, the connection between the router and modem was not established properly. Make sure they are connected properly whether you have used a wired or wireless mode to connect them.
Fix 4: Set it Up Again
Perhaps you have not used the correct steps to set up your Netgear router after resetting it which is why it is not working now. So, reset your device once again by pressing the Reset button. Make sure the router is powered up while you are resetting it. After you have restored the factory settings on the router, it is time that you set it up again. You can use any method like the manual method, WPS method or the Nightahwk app to get the job done. You can always refer to the user manual to know the exact steps to complete the setup process.
The Closing Note
We are very sure that after you are done with setting up your device, you will no longer be facing the same issue under discussion.