WiFi Repeater Not Working after Update [How to Fix]
Firmware updates are intended to improve the outputs delivered by a networking device. But, the problems can increase if the opposite happens. Yes, we are talking about the situation where a device denies working post firmware update. Have you also updated the firmware of your repeater via the Wireless-N WiFi repeater login portal and are now facing the same problem? If yes, then it is suggested that you pay attention to this very troubleshooting guide. Here, we have highlighted some pointers that can help you do away with the problem like it was never in existence.
Reasons: WiFi Repeater Not Working after Update
There are not so many reasons due to which a Wireless-N WiFi repeater stops working post an update. But the most common reason is the uploading of the wrong firmware file. We believe that when you were about to upload the firmware file on the extender’s administrative portal, you accidentally selected a wrong file. There are also chances that you downloaded an incorrect firmware file in the first place.
Well, whatever mistake might have happened from your end, know that uploading a wrong firmware file on the WiFi repeater not only degrades its performance but also tends to make your extender non-working forever. Thus, we suggest you download the correct firmware version for your extender/repeater via the download center and see if things turn back. If yes, then no more troubleshooting is required. Otherwise, you need to have a look at the techniques mentioned below.
Quick Tip: Do you know that an extender or other networking devices reboot as a part of a firmware update process? Well, now you know. There are chances that your extender is in the boot up state during the update process that you are mistaking as an inactive state. Thus, you are supposed to wait for a while before reaching any conclusion.
Solved: Wireless-N WiFi Repeater Not Working after Update
- Restart the WiFi Repeater
Technical glitches are quite potent to create any issue with your WiFi repeater. Maybe your repeater has stopped working after an update due to their existence. Thus, we recommend you kick them off as soon as possible. Are you wondering how? Simply, restart your range extender. To make this happen, you need to first of all disconnect all the devices connected to the repeater’s network. You also have to disconnect the extender-router connection. Once done, power down the WiFi repeater, and wait for 10-15 minutes. Power it up and check whether it resumes its working state or not. If not, you should have a look at the next tip.
- Check the Power Supply
Did the repeater suffer a power outage during the firmware update process? If yes, then there are high chances that the socket into which you have plugged your range extender has become damaged? Know that it can also prevent you from accessing the Wireless-N WiFi repeater setup portal. Thus, you need to have a look at the socket and in case it is found damaged, you must not wait more than a moment to connect your Wireless N WiFi repeater to a socket that is well working. Has your extender regained the working state now? If yes, then good, otherwise, reset the repeater.
The End Lines
We have now reached the end of the post explaining what to do if your Wireless-N WiFi repeater does not work after a firmware update. It is expected that after restarting the extender and uploading the correct firmware file, things have started working your way.
On the off-chance, you are still struggling to make your WiFi repeater working, you are suggested to perform a factory default reset. It will wipe out all the major and minor issue from the WiFi repeater and will provide you with the ability to set it up once again. Thus, reset the Wireless-N repeater and set it up. Do not forget to upgrade the firmware once again.