Can’t Connect Netgear WiFi Extender to Cox Gateway [Solved]
Are you finding it an ordeal to create a link between your Cox gateway and the Netgear WiFi range extender? Well, it is not a big deal. There are chances that you were careless somewhere. On the deep analysis of the concept of connection between two devices, you will be able to learn where you might have went wrong and what can be done to fix things. This is to inform you that Cox gateways are two in one devices. It means that if you have performed Cox modem setup, the troubleshooting tips automatically apply to the router. Keep reading.
Reasons Why You Can’t Connect Netgear Extender to Cox Gateway
There can be numerous reasons behind facing the connectivity issue between Netgear WiFi range extender and the Cox gateway. But, the distance separating them plays a pivotal role in deciding whether you will be able to link both devices successfully or not.
This is for your general information that two devices will be able to communicate wirelessly only if the distance through which you have separated them is decent. In other words, you have to maintain a distance of 8 to 10 ft between them. If the distance is found more than that, you can forget about connecting both devices. However, too less distance is also not suggested. The reason being that decimating this distance will result in a clash of signals emitted by both networking devices. Just in case, your devices are sharing an appropriate distance, you are suggested to pay attention to the following points to learn other reasons behind the issue:
- You have not used a damage-free cable to connect your WiFi devices.
- The extender or router isn’t getting a stable power supply.
- Any of the WiFi devices is surrounded by signal interference-creating factors.
So, these were the topmost causes that might be responsible for creating a connectivity issue between a Netgear wireless range extender and a Cox gateway. Assuming that you have now overviewed them, it is suggested that you take the aid of the troubleshooting techniques jotted down in the upcoming section.
Fixed: Can’t Connect Netgear WiFi Extender to Cox Gateway
- Use a Damage-free LAN Cable
Run an eye scan on the LAN cable holding a direct connection between your Netgear range extender and the WiFi gateway. In case it is found damaged, then you should not wait much time getting it replaced with a new one. If everything is perfect with the cable you are suggested to check that the connection is finger-tight and make required changes. And yes, you also need to make sure that the cable has been inserted into the correct ports of your WiFi devices.
- Ensure a Stable Power Supply
If any of the devices are not getting a stable power supply, then also you won’t be able to connect WiFi extender to Cox gateway. This is because whenever a device gets an improper power supply, it is most likely to get stuck in a reboot loop which is not a good thing at all. To be sure about everything, we suggest you have a look at the power sockets into which you have plugged your host gateway and the Netgear extender. These sockets are supposed to be free of damages plus must be capable of supplying the sufficient amount of power to your devices.
- Change the Location of Your Devices
There is a high possibility that either your Cox gateway or the Netgear extender is present in a location that experience signal interference. Just to be sure, check the surroundings of both devices. Did you find any object that contains a lot of water or a device that emit electromagnetic frequencies? If yes, then you must not wait to change the location of that particular device. Also, make sure that you’re not giving it a space near reflexive surfaces.
The Concluding Words
The tips mentioned above will suffice to help you create a successful connection between the Netgear extender and a Cox router/modem. It is now anticipated that you have successfully troubleshot the issue. To make things smoother, it is recommended that you restart the entire home network and resume everything after that.
